Heiland Splitgrade Manual

Simplifies and accelerates the processing of fine art prints while saving time, paper and chemistry

The manual version can be used with condenser and diffuser enlargers. It can be used with colour and monochrome heads.

Because of the modular SPLITGRADE system, you can upgrade the manual version later on to an automated version or with Heiland's LED cold light source.

Technical data

Measuring probe: 3mm diameter spot reading sensor measures negative density and contrast
Exposure control: Built-in exposure timer
Measuring range: 0.01 to 10 lux (10 ƒ-stops)
Exposure time range: 1.0 to 500 seconds
Exposure time resolution: 0.1 seconds
Contrast setting: In 0.1 grade steps following measurement of the negative contrast or manual setting with automatic density compensation
Measuring is done in 0.1 grade steps. Manual adjustment can also be done in 0.1 grade steps with an automatic time compensation Time setting: 0.1 ƒ-stops or 0.1sec steps
Measurement basis: Approx. 90% of paper maximum density
Calibration: Factory programmed for 29 types of paper. Adjustable for fine tuning
Interfaces: Measurement probe, foot-switch, USB port
Display: Back-lit LCD alphanumeric, 4 lines
Dimensions of controller: 260x160x80 mm (length x width x height)
Weight: 1 kg
Fuse: 4A, time lag
Operating voltage / Power consumption: 90 ... 250V AC 45 ... 65 Hz. / 7 VA
Maximum load: 1000W
Temperature range: 15 ... 40° Celcius
Relative humidity: 0 ... 70 %
Delivery content: Controller, probe, foot switch, connectors, manual